Concerns with Jard billet lower

Discussion in 'The Black Rifle' started by MechTech, Mar 3, 2013.

  1. MechTech Moderator/ Damn Yankee

    Member Since:
    Aug 7, 2011
    Message Count:
    769
    I got this Jard billet lower up from a GB auction. I looked it over after picking it up from my FFL today and I think they machined it a little thin at the top of the magwell. I am going to fire off some pics to Jard in the morning. It is only about .035" and I am worried about it fracturing. What do you think?
    [IMG]
    [IMG]
    [IMG]
  2. Mudcat Member

    Member Since:
    Mar 3, 2013
    Message Count:
    33
    Looks kind of thin to me, I would probably call them too. Chances are it will never be an issue but if you do have an issue and didn't call you may be stuck.
  3. MechTech Moderator/ Damn Yankee

    Member Since:
    Aug 7, 2011
    Message Count:
    769
    I emailed the pics to Jard last night and Dean called me this evening. He said it shouldn't be an issue, but if I am concerned about it, they have no problem swapping it with a new one. Even if I were to have problems with it down the road, he said they will still stand behind it. I think I am going to go ahead and build it. At the least, it's piece of mind knowing Jard stands behind their products!

Share This Page